Flashing Around Chimney Cost
Flashing Around Chimney Cost – Releading a chimney, better known as blinking or blinking again, is the process of applying the new lead sheets to the junction between the chimney and the ceiling. This process should be repeated as part of regular maintenance. Without quality flickering, water can enter this space and cause rot, mold growth and roof leaks that could lead to costly repair bills. Remove the old blinking. Use a lever to get rid of the old leader.
If necessary, use a chisel to break the seal between the flicker and chimney, and to remove any roofing cement. Apply membrane to ceilings. Place 1 wide strips of waterproof self-adhesive roof membrane around the entire base of the foot flashing around chimney cost, so that the bricks are about four inches thick. Install bottom fountain. Use a pair of metal scissors to cut a piece of the intermittent pre bent lead base to the same width as the front of your fireplace. Install stepped flashing.
Cut a pre-bent pass piece to blink to allow the end to bend about 1 ½ inches around the front of the fireplace. Place this piece on the bottom end of one side of the fireplace, allowing your front corner to overlap the flashing base you have already installed. Make sure that the bottom of each piece of lead flashing around chimney cost is under the corresponding course of shingles.